User's Manual
Table Of Contents
- About This Guide
- Safety
- Introducing the Alaris 3-D Printing System
- Installing Objet Software
- Using Objet Studio
- Using Job Manager
- Operating & Maintaining the Alaris30 3-D Printer
- Starting the Alaris30 Printer
- Loading Model and Support Cartridges
- Producing Models
- Resuming Production After Printing has Stopped
- Changing the Model Material
- Keeping the Alaris Printer in Idle Mode
- Shutting Down the Alaris Printer
- Maintaining the Alaris Printer
- Routine Maintenance Schedule
- Cleaning the Print Heads
- Pattern Test
- Improving Print Quality
- Cleaning and Replacing the Wiper
- Cleaning and Replacing the Roller Waste Collector
- Aligning the Print Heads
- Replacing Print Heads
- Calibrating the Load Cells
- Replacing the Odor Filter
- Replacing the UV Lamp
- Replacing the Waste Container
- Cleaning the Exterior Panels
- Backing-Up and Restoring Printer Settings
- ReInitiate Wizard
- Handling Printed Models
DOC-24000 Rev. A 5–13
Alaris30 User Guide
Figure 5-16: Object properties dialog box, Transform tab
Youcanmakeprecisechangestoanobjectonthebuildtraybyselectingthe
object(eitheronthetrayorinthetrayhierarchypane),changingitsvalues
inthedialogbox,andclicking
Change Units.
Note: You can only change the height of the objects on the build tray if this
is allowed by the Objet Studio settings (see “Object Position on the
Z-Axis” on page 5-11.)
ThepropertiesdisplayedintheTransformtaboftheobjectpropertiesdialog
boxareabsolutevalues,representingtheactualpositionoftheobjectonthe
buildtray.Anotherwayofrepositioningobjectsonthetrayusingprecise
valuesisbyapplyingchangestoobjectpropertiesrelativetothecurrent
posi
tion.TherearetwoRelativeTransformdialogboxesavailable:
• TheR.Transtaboftheobjectpropertiesdialogbox.
Figure 5-17: Object properties dialog box, R. Trans tab
• TheRelativeTransformdialogbox,accessiblefromtheObjectmenu.
Figure 5-18: Relative Transform dialog box
DRAFT 4 - July 11, 2010