User's Manual
Table Of Contents
- About This Guide
- Safety
- Introducing the Alaris 3-D Printing System
- Installing Objet Software
- Using Objet Studio
- Using Job Manager
- Operating & Maintaining the Alaris30 3-D Printer
- Starting the Alaris30 Printer
- Loading Model and Support Cartridges
- Producing Models
- Resuming Production After Printing has Stopped
- Changing the Model Material
- Keeping the Alaris Printer in Idle Mode
- Shutting Down the Alaris Printer
- Maintaining the Alaris Printer
- Routine Maintenance Schedule
- Cleaning the Print Heads
- Pattern Test
- Improving Print Quality
- Cleaning and Replacing the Wiper
- Cleaning and Replacing the Roller Waste Collector
- Aligning the Print Heads
- Replacing Print Heads
- Calibrating the Load Cells
- Replacing the Odor Filter
- Replacing the UV Lamp
- Replacing the Waste Container
- Cleaning the Exterior Panels
- Backing-Up and Restoring Printer Settings
- ReInitiate Wizard
- Handling Printed Models
DOC-24000 Rev. A 6–5
Alaris30 User Guide
Figure 6-3: Printer status screen
Configuring
User Alerts
JobManagercanalertyouandotherstothestatusofthejobssenttothe
serverforprinting.Thefollowingeventscanbereported:
• Thelevelofmodelorsupportmaterialislow.
• Thejobwasinterrupted.
• Thejobwascompletedsuccessfully.
Tosende‐mailandSMSmessages,makesurethate‐mailsoftware
supportingMAPIisinstalledontheprinter’sservercomputer.TosendSMS
messages,thecellularphoneservicemustsupportthetransmissionofe‐
mailmessagesbySMS.WithSMSalerts,onlythesubjectlineofthee‐ma
il
messageistransmitted.
Note: In the e-mail program, make sure the security settings are set to
“low” and add the server Job Manager to the “trusted” list (select
Tools > Options, Security tab).
To configure Job Manager to send notifications and alerts for your jobs:
1. ClickorselectNotificationsfromthe3‐DPrintermenu.
TheNotificationsdialogboxopens.
Figure 6-4: User alerts settings
DRAFT 4 - July 11, 2010