User's Manual
Table Of Contents
- About This Guide
- Safety
- Introducing the Alaris 3-D Printing System
- Installing Objet Software
- Using Objet Studio
- Using Job Manager
- Operating & Maintaining the Alaris30 3-D Printer
- Starting the Alaris30 Printer
- Loading Model and Support Cartridges
- Producing Models
- Resuming Production After Printing has Stopped
- Changing the Model Material
- Keeping the Alaris Printer in Idle Mode
- Shutting Down the Alaris Printer
- Maintaining the Alaris Printer
- Routine Maintenance Schedule
- Cleaning the Print Heads
- Pattern Test
- Improving Print Quality
- Cleaning and Replacing the Wiper
- Cleaning and Replacing the Roller Waste Collector
- Aligning the Print Heads
- Replacing Print Heads
- Calibrating the Load Cells
- Replacing the Odor Filter
- Replacing the UV Lamp
- Replacing the Waste Container
- Cleaning the Exterior Panels
- Backing-Up and Restoring Printer Settings
- ReInitiate Wizard
- Handling Printed Models
DOC-24000 Rev. A 6–7
Alaris30 User Guide
Server Job Manager
WhenyouopentheserverObjetStudio/JobManagerprogramforthefirst
time,oriftheprogramisnotconnectedtoanObjet3‐Dprinter,youare
promptedtoconnecttoaprinter.Ifyouclick
Yesinthedialogbox,the
SettingNetworkConnectiondialogboxopens(seefigure 6‐6).
Youcanswitchtheserverconnectiontoanotherprinteratanytime.
To set (or change) the printer connection:
1. Fromthe3DPrintermenu,selectSet Printer.
2. IntheSetPrinterdialogbox,click
Connect...
Figure 6-6: Printer connection dialog box
3. Typethenameofthecomputerinsidetheprinter,orclickBrowseto
findandselectit.Click
OKtoclosethedialogbox.
To connect to a printer, the printer must be on and connected to the local
network.
DRAFT 4 - July 11, 2010