User's Manual
Table Of Contents
- About This Guide
- Safety
- Introducing the Alaris 3-D Printing System
- Installing Objet Software
- Using Objet Studio
- Using Job Manager
- Operating & Maintaining the Alaris30 3-D Printer
- Starting the Alaris30 Printer
- Loading Model and Support Cartridges
- Producing Models
- Resuming Production After Printing has Stopped
- Changing the Model Material
- Keeping the Alaris Printer in Idle Mode
- Shutting Down the Alaris Printer
- Maintaining the Alaris Printer
- Routine Maintenance Schedule
- Cleaning the Print Heads
- Pattern Test
- Improving Print Quality
- Cleaning and Replacing the Wiper
- Cleaning and Replacing the Roller Waste Collector
- Aligning the Print Heads
- Replacing Print Heads
- Calibrating the Load Cells
- Replacing the Odor Filter
- Replacing the UV Lamp
- Replacing the Waste Container
- Cleaning the Exterior Panels
- Backing-Up and Restoring Printer Settings
- ReInitiate Wizard
- Handling Printed Models
DOC-24000 Rev. A 7–13
Alaris30 User Guide
8. Tocontinue,clickNext.
9. Whenpromptedbythewizardscreen,removethematerialcartridges.
Selectthecheckboxtoconfirmthatyouhavedoneso,andclickNext.
Figure 7-15: Remove Cartridge confirmation screen
10. Whenprompted,loadthenewcartridge(s)andclosethedrawer.
Confirmthisinthewizardscreenandclick
Next.
Afteridentifyingthenewcartridge(s),theAlarisprinterbeginsfilling
theprintheadswiththenew
material.
Figure 7-16: Material replacement: filling heads with new material
11. Whenthefinalwizardscreenappears,makesurethatthescreen
displaysthenewly‐loadedmaterial(s).Click
Donetoclosethewizard.
Theprinter‐controlinterfaceisautomaticallyupdated,andshould
displaythenewmaterials.TheObjetStudiointerface(ontheprinter‐
serverworkstation)isalsoupdated,anddisplaysthenewmaterials.
CAUTION: Dispose of all material cartridges in accordance with all
applicable laws and regulations. If necessary, the cartridges can be
disassembled for recycling. If this is done, protect the person handling the
cartridges from direct exposure to uncured resins.
DRAFT 4 - July 11, 2010