User's Manual

Using Objet Studio
5–70 DOC08010 Rev. A (DRAFT 1)
Setting the
Printer
Connection
WhenȱanȱObjetȱ3Dȱprinterȱisȱinstalled,ȱtheȱserverȱcomputerȱisȱconnectedȱtoȱ
thatȱprinter.ȱNormally,ȱthereȱshouldȱbe ȱnoȱreasonȱtoȱchangeȱthisȱconnection.ȱ
Occasionally,ȱhowever,ȱyouȱmayȱneedȱtoȱresetȱtheȱconnection,ȱtoȱconnectȱ
theȱserverȱtoȱanotherȱprinter,ȱorȱtoȱuseȱObjetȱStudioȱinȱoffȬlineȱmodeȱ
(without
ȱaȱprinterȱconnection).
To set (or change) the printer connection:
1. OnȱtheȱJobȱManagerȱribbon,ȱinȱtheȱ3DȱPrinterȱgroup,ȱclickȱ .
2. InȱtheȱSetȱPrinterȱdialogȱbox,ȱclickȱ
Connect.
Figure 5-102: Connecting to a printer (A)
3. EnterȱtheȱcomputerȱnameȱorȱitsȱIPȱaddress,ȱorȱclickȱBrowseȱtoȱfindȱandȱ
selectȱit.
Figure 5-103: Connecting to a printer (B)
4. ClickȱOK.
Whenȱtheȱconnectionȱisȱestablished,ȱObjetȱStudioȱisȱconfiguredȱtoȱ
prepareȱprintȱjobsȱforȱthatȱprinter.
If you can see the material levels in the Job Manager screen (see
figure 5-101 on page 68), Objet Studio is connected to the printer.