User's Manual

DOC08010 Rev. A (DRAFT 1) 5–71
Stratasys P750K User Guide
Off-line Mode
YouȱcanȱuseȱObjetȱStudioȱtoȱprepareȱtraysȱforȱprintingȱinȱoffȬlineȱmode,ȱonȱ
aȱremoteȱcomputerȱorȱwhenȱtheȱprinterȱconnectionȱisȱnotȱavailable.ȱYouȱalsoȱ
useȱoffȬlineȱmodeȱtoȱprepareȱtraysȱforȱprintingȱwithȱotherȱprinters.ȱInȱthisȱ
case,ȱifȱObjetȱStudioȱisȱcurrentlyȱconnectedȱtoȱa
ȱprinter,ȱyouȱmustȱchangeȱtoȱ
offȬlineȱmodeȱbyȱremovingȱthisȱconnection.
To disconnect Objet Studio from the printer:
1. OnȱtheȱJobȱManagerȱribbon,ȱinȱtheȱ3DȱPrinterȱgroup,ȱclickȱ .
2. InȱtheȱSetȱPrinterȱdialogȱbox,ȱclickȱ
Connectȱ(seeȱfigure 5Ȭ102).
Figure 5-104: Disconnecting Objet Studio from a printer (A)
3. InȱtheȱPrinterȱConnectionȱdialogȱbox,ȱdeleteȱtheȱcomputerȱname/IPȱ
address.
Figure 5-105: Disconnecting Objet Studio from a printer (B)
4. ClickȱOK.
“Unknown”ȱappearsȱinȱtheȱprinterȬnameȱfield.
5. Clickȱ
OK.
6. InȱtheȱpopȬupȱmessage,ȱconfirmȱthatȱyouȱwantȱtoȱworkȱinȱoffȬlineȱmodeȱ
byȱclickingȱ
No.
Figure 5-106: Off-line message
WhenȱObjetȱStudioȱisȱinȱoffȬlineȱmode,ȱyouȱcanȱconfigureȱitȱforȱpreparingȱ
printȱjobsȱforȱdifferentȱprinters.