User's Manual

DOC08010 Rev. A (DRAFT 1) 6–9
Stratasys P750K User Guide
Resuming Production After Printing has Stopped
Ifȱtheȱprintingȱprocessȱisȱinterrupted,ȱObjetȱStudioȱstopsȱsendingȱslicesȱtoȱ
theȱprinter.ȱThisȱcanȱhappen,ȱforȱexample,ȱifȱtheȱprintingȱmaterialȱrunsȱoutȱ
inȱtheȱmiddleȱofȱaȱprintȱjob,ȱandȱyouȱdon’tȱreplaceȱtheȱemptyȱcartridgeȱ
immediately.ȱAfterȱtheȱprinterȱchangesȱtoȱStandbyȱorȱIdleȱmode,ȱyouȱneed
ȱtoȱ
resumeȱprintingȱfromȱtheȱJobȱManagerȱscreenȱofȱObjetȱStudio.
To continue printing the model:
1. Ifȱtheȱprinterȱisȱinȱofflineȱmode,ȱswitchȱitȱtoȱonlineȱmodeȱbyȱclickingȱtheȱ
redȱbuttonȱatȱtheȱbottomȱofȱtheȱprinterȱinterfaceȱ(seeȱfigure 6Ȭ3ȱonȱ
page 3).
Theȱbuttonȱchangesȱfromȱredȱtoȱgreenȱ(seeȱfigure 6Ȭ4ȱonȱpage 6).
2. Ifȱyouȱdon’tȱknowȱwhyȱprintingȱhasȱstopped,ȱmakeȱsureȱthat
ȱtheȱ
connectionȱbetweenȱtheȱprinterȱandȱtheȱserverȱcomputerȱisȱactive.
3. InȱtheȱJobȱManagerȱscreenȱofȱObjetȱStudio,ȱclickȱtheȱResumeȱiconȱ .
4. InȱtheȱContinueȱfromȱSliceȱdialogȱboxȱthatȱappears,ȱconfirmȱtheȱsliceȱ
number,ȱafterȱcheckingȱtheȱprinterȱinterface.
Figure 6-6: Printer interface after interrupted printing
Figure 6-7: Continue from Slice confirmation in Objet Studio (Job Manager
screen)
5. If,ȱforȱanyȱreason,ȱtheȱcorrectȱnumberȱdoesȱnotȱappearȱinȱtheȱdialogȱ
box,ȱenterȱtheȱnumberȱandȱclickȱ
OK.
After printing stops, the printer goes into Standby mode, when heating of
print heads is reduced. About 10 hours later, the printer goes into Idle mode,
when heating of print heads is stopped.
Printer mode
Last slice printed