User's Manual

Operating & Maintaining the Stratasys P750K 3D Printer
6–14 DOC08010 Rev. A (DRAFT 1)
11. Readȱtheȱwarningȱmessage,ȱandȱclickȱOK.
Figure 6-10: Final wizard screen
12. ClickȱDoneȱtoȱcloseȱtheȱwizard.
TheȱprinterȬcontrolȱapplicationȱisȱautomaticallyȱupdated,ȱandȱtheȱ
interfaceȱdisplaysȱtheȱnewȱmaterial(s).ȱTheȱObjetȱStudioȱapplicationȱ(onȱ
theȱprinterȬserverȱcomputer)ȱisȱalsoȱupdatedȱandȱdisplaysȱtheȱnewȱ
material(s).
13. Inspectȱtheȱareaȱaroundȱtheȱpurgeȱunitȱandȱcleanȱit,ȱifȱnecessary.
Advanced
Settings
TheȱAdvancedȱSettingsȱdialogȱboxȱenablesȱyouȱtoȱconfigureȱtheȱMaterialȱ
Replacementȱwizardȱforȱspecialȱpurposes.ȱIfȱnecessary,ȱclickȱ
Advanced
Settings
ȱinȱtheȱMaterialȱReplacementȱOptionsȱscreenȱbeforeȱclickingȱNext.
Figure 6-11: Advanced Replacement settings
If you continue, you must complete the material replacement process
before you can produce models. To replace material at another time, click
Cancel. If you continue (by clicking OK) and you do not complete the
process, you will need to run the wizard again before producing models.
CAUTION: Dispose of all material cartridges in accordance with all
applicable laws and regulations. If necessary, the cartridges can be
disassembled for recycling. If this is done, protect the person handling
the cartridges from direct exposure to uncured resins.