User's Manual

Operating & Maintaining the Stratasys P750K 3D Printer
6–24 DOC08010 Rev. A (DRAFT 1)
5. Whenȱtheȱfollowingȱscreenȱappears,ȱopenȱtheȱcover.
Figure 6-24: Wiper Cleaning wizard during steps 6–10
6. Putȱonȱtheȱcleaningȱgloves.
7. Usingȱaȱgenerousȱamountȱofȱalcoholȱonȱtheȱcleaningȱcloth,ȱremoveȱanyȱ
materialȱremainingȱonȱtheȱwiperȱandȱtheȱsurroundingȱarea.
8. Removeȱanyȱpiecesȱofȱwasteȱmaterialȱcollectedȱinȱtheȱpurgeȱunit.ȱIfȱ
necessary,ȱremoveȱtheȱwasteȱcollectorȱtoȱcleanȱit.ȱWipeȱtheȱrubberȱseal.
Figure 6-25: Purge unit waste collector
Note: When returning the waste collector to the purge unit, make sure to
insert it as shown.
9. Inspectȱtheȱwiper.ȱ
Ifȱtheȱwiperȱisȱscratched,ȱtornȱorȱworn,ȱorȱifȱyouȱcannotȱcleanȱitȱ
completely,ȱreplaceȱit.
a. Graspȱitȱandȱpullȱitȱupȱandȱoutȱofȱitsȱbracket.ȱ
b. Insertȱtheȱnewȱwiperȱblade,ȱmakingȱsureȱthatȱitȱisȱstraightȱandȱsecuredȱ
wellȱonȱbothȱsides.
10. Inȱtheȱwizardȱ
screenȱ(seeȱfigure 6Ȭ24),ȱconfirmȱthatȱtheȱwiperȱbladeȱisȱ
clean,ȱandȱclickȱ
Next.
11. Removeȱallȱtoolsȱandȱcleaningȱmaterialsȱfromȱtheȱprinter,ȱandȱcloseȱtheȱ
cover.