User's Manual

Operating & Maintaining the Stratasys P750K 3D Printer
6–54 DOC08010 Rev. A (DRAFT 1)
3. Inȱtheȱfollowingȱscreen,ȱselectȱtheȱUVȱsensorȱandȱmeasuringȱdeviceȱtoȱ
beȱused.
Figure 6-83: UV device selection
4. Makeȱsureȱthatȱtheȱbuildȱtrayȱisȱclearȱ(empty),ȱconfirmȱthisȱinȱtheȱ
wizardȱscreenȱandȱclickȱ
Next.
Figure 6-84: Printer preparation
¾ WhenȱusingȱtheȱStratasysȱUVȱsensorȱ(TOLȬ03005ȬS),ȱcontinueȱwithȱ
“UVȱsensorȱconnectedȱtoȱprinter,”ȱbelow.
¾ WhenȱusingȱaȱstandȬaloneȱradiationȱmeter,ȱcontinueȱwithȱ“ExternalȱUVȱ
meter”ȱonȱpage 57.
UV Measuring Device
When you use the Stratasys UV sensor (TOL-03005-S), you connect it to the
printer. The wizard automatically measures and calibrates the UV radiation.
If you use a stand-alone UV radiation meter, you need to manually enter the
readings from the meter in the wizard screens.