User's Manual

DOC08010 Rev. A (DRAFT 1) 5–11
Stratasys P750K User Guide
Figure 5-10: Assembly check box selected—stl files are placed as an assembly
Figure 5-11: Assembly check box not selected—stl files are placed as parts
TheȱModelȱSettingsȱribbonȱisȱdisplayedȱwhenȱobjectsȱareȱplacedȱonȱtheȱ
buildȱtray.
5. Selectȱanyȱofȱtheȱfollowingȱoptions,ȱasȱrequired:
• Units—Millimetersȱorȱinchesȱforȱtheȱobject’sȱunitsȱofȱmeasure.
Theȱ3Dȱfileȱcontainsȱtheȱobjectȇsȱproportions, ȱbutȱnotȱitsȱunitsȱofȱ
measure.ȱTherefore,ȱmakeȱsureȱtoȱcorrectlyȱselectȱeitherȱ
millimetersȱ
orȱ
inchesȱwhenȱinsertingȱanȱobject.ȱOtherwise,ȱtheȱsizeȱofȱtheȱobjectȱ
onȱthe ȱbuildȱtrayȱwillȱbeȱeitherȱmuchȱtooȱlarge ȱorȱmuchȱtooȱsmall.ȱToȱ
changeȱtheȱmeasurementȱunitsȱofȱobjectsȱalreadyȱplacedȱonȱtheȱtray,ȱ
seeȱ“MeasurementȱUnits”ȱonȱpage 31.
• Number of copies—Howȱmanyȱcopiesȱofȱthisȱobjectȱtoȱplaceȱonȱtheȱ
buildȱtray.
• Orient Automatically—Automaticallyȱorientȱobjectsȱonȱtheȱbuildȱtrayȱ
forȱefficientȱmodelȱbuilding.
• Assembly—Markȱthisȱcheckȱboxȱifȱyouȱselectedȱmultipleȱstlȱfilesȱthatȱ
areȱpartȱofȱanȱassembly.