Installation Guide

6
Fasten the top and bottom Wall Channels to the Wall Sheets using 10x16
self-drilling screws through each pilot hole, ignoring the two holes at each
end (Figure 1.8).
10x16 self-drilling screw
Wall Channel
Figure 1.8
Figure 1.9
Coloured Rivet
Repeat this process to assemble the remaining walls. A left wall, right wall
and rear wall should be assembled before continuing.
Bottom Channel
10x16 self-drilling screw
Figure 2.1
Lay out sheets onto trestles / blocks. Refer to figure 1.5 for lapping details. Fit
the Bottom Channel and Sliding Rail over the Wall Sheets (Figure 2.1).
The end of the Channels should fit up against the ends of the Corner
Wall Sheet (Refer Figure 1.6).
FRONT WALL ASSEMBLY
Figure 2.0
Note: All Handi-Mate™ front walls are assembled in the
same manner. Refer to “Handi-Mate™ Model Sizes” section
for specific front wall sheeting quantities & configurations.
Sliding Rail
Bottom Channel
Door Jamb
10x16 self-drilling screw
Door Jamb
Corner Wall Sheet
Split Wall Sheet
Top
Sliding Rail
Bottom Channel
Fasten one 10x16 self-drilling screw through the third pilot hole of the
Bottom Channel and into the corresponding Wall Sheet crest (Figure 2.2).
Fasten another 10x16 self-drilling screw through the third pilot hole of the
Sliding Rail and into the Wall Sheet.
Figure 2.2
Sheet Layout
Join any overlapping sheets to one another using coloured rivets through
the mid-span of lapping crests (Figure 1.9).
Drill a hole with the ø3.5mm drill bit into the centre of the lapping crests.
Use a Rivet Gun to rivet the sheets together.