Installation Guide

7
Fit the Door Jamb over the Wall Sheet, ensuring it is inside the Bottom
Channel and Sliding Rail (Figure 2.3).
Fasten one 10x16 self-drilling screw through the underside of the Bottom
Channel & Sliding Rail and into the Door Jamb (Figure 2.5).
Figure 2.3
Figure 2.6
Door Jamb
Sliding Rail
Bottom Channel
Sliding Rail
Bottom Channel
10x16 self-drilling screw
Figure 2.5
Door Jamb
Approx.
150mm
Coloured Rivet
DOOR ASSEMBLY
Figure 3.0
Bottom Door Channel
Vertical Door Channel
Top Door Channel
Vertical Door Channel
Wall Sheet
Split Door Sheet
10x16 wafer screw
Note: All Handi-Mate™ doors are assembled in the same manner.
Figure 2.4
Sliding Rail
Bottom Channel
10x16 self-drilling screw
Door Jamb
Slide the other Door Jamb approximately 150mm into the Bottom
Channel and Sliding Rail. Ensure the open end of the Door Jamb is facing
away from the sheets (Figure 2.6). A coloured rivet should be used to join
sheet overlaps together (Refer Figure 1.9).
Crest-Fix the Bottom Channel & Sliding Rail to the wall sheets using
three 10x16 self-drilling screws through the pilot holes in each (Figure 2.4).
Ensure all sheets are crest-fixed.