Full Product Manual

STEP 6
Push slats down into side frame ensuring spacer
blocks are placed between each slat.
Install tip: Place spacer block on bottom plate
before pushing first slat down so that first slat sits
on a spacer block.
Spacer blocks supplied in kit allow slat spacing
of ⁄” (9mm) or ⁄” (20mm). If a dierent spacing
is required, source appropriate spacer blocks to
achieve your desired slat spacing.
Spacer blocks are NOT removed after inserting slats
and remain as part of the assembled screen.
STEP 7
Once all slats are in place, carefully reattach top cap
with screws.
FINISHED!
STEP 5
Cut aluminium slats 1” (25mm) less than total width
of opening. Refer to measurement in step 1.
The 1” (25mm) deduction takes into account
thickness of side frame on both sides of the screen.
1” (25mm) total deduction (cut one end only)
Rotate block
for ⁄” (9mm)
or ⁄” (20mm)
spacing
HEIGHT ADJUSTMENT
To adjust height simply cut outer frame and inner gripping channel as required to desired height.
NOTE: Exact heights depend on spacing of slats. Please take care before cutting side frames to ensure height has
been calculated correctly
SIDE FRAME
ASSEMBLY GUIDE