User's Manual Part 3

STRATEGIC Technologies Inc. Domestic Violence Installation
Domestic Violence Installation
Victims Installation
Pre-Installation
A. If your equipment is monitored by our Monitoring Center:-
- Fax the Enrollment Form to the Monitoring Center, giving as much time as possible (½
hour minimum) before the unit is to be hooked up inside the victims home. The Monitoring
Center must be notified before the unit calls in. The form should be clearly marked
indicating this unit is a domestic violence unit and is located in the victims home.
B. If you monitor your own equipment:-
- Assure you have entered the victims data on your system before you install the unit in the
offenders home. The curfew schedule should be entered with AWAY time all day. See
Page 50 For a complete listing of all events generated by the PRU+.
PRU+ Installation
1. Position the PRU+: Remove the PRU+ and AC power adapter from the case. Place the
PRU+ in a central location, preferably closer to the participant’s bedroom than their living area,
elevated at least three feet / ninety centimetres from the floor.
2. Plug in the PRU+: Plug one end of the AC power adapter into a standard 110 Volt electrical
outlet and the other end into the PRU+. Note : Do not connect the telephone line. The
PRU+ will turn on, displaying the title screen. It will then display the date and time screen. The
power and charge LED will be lit. The charge LED will go out when the PRU+ internal battery
is fully charged.
3. Clear Stored Events: Press and hold the PRU+ button on the LOCK until the PRU+
prompts “Please Wait....”. When the display prompts “B=Function Mode” press “B” button
once. The display will prompt “B=Clear Events”. Press “B”, the display will now prompt “A=**
Clear ** / B=Cancel”. Press “A” to clear all events.
Transmission Checks
Check the Participant’s PID
At this time, the PID that will monitor the offender should also be checked. This will verify that the
system operates correctly.
5. Install the Battery: Remove the PID , baseplate, one strap, one locking bar, one locking pin
and the battery from the case. Simply place the battery into the PID battery well so that the
alignment mark on the battery lines up with the alignment mark on the PID. Rotate the battery
counterclockwise until the tabs on the battery slide under the two lock down posts. (See Figure
3 : installing the battery in the PID).