User's Manual Part 4

STRATEGIC Technologies Inc. System Definitions
LOCK ........................... Unit Access Controller. This device is used to access Special
Function Mode on a PRU+ and is used to reset the strap
tamper alarm on a PID.
Locking Pins................. Plastic pins that hold the PID and baseplate together.
Memory ........................ The location in the PRU+ where events are stored. The PRU+
can store up to 2500 events.
Passive......................... The ability of the PRU to monitor an participant without being
attached to a telephone line.
PID .............................. Personal Identification Device. This device attaches to the
participants leg and identifies the presence of the participant to
the PRU+.
PRU+ ........................... Platinum Plus Receiver Unit Series. This device is placed in
the area of confinement and monitors the participants activity
via the PID.
PVU.............................. Personnel Verification Unit. Used to monitor the participant
away from the area of confinement.
Reset (PID)................... The act of clearing the strap sever, strap tamper, pid low
battery and pid case open alarm.
Reset (PRU+)............... The act of starting or re-starting the PRU+ in Run Mode.
RSSI............................. Receiver Signal Strength Indication. This is a value between 1
- 255 that indicates the relative distance the PID is located
from the PRU+.
RF . .............................. Radio Frequency. The method in which the signal is sent from
the PID to the PRU+.
Run Mode..................... The area of confinement is monitored in this mode. The
display has the date and time on the top line.
Signal ........................... Information sent by the PID
Special Function
Mode ............................ Accessible by using the LOCK. Used when installing the
PRU+
Strap............................. Band that holds the PID to the participant.
Strap Sever .................. Alarm that indicates the strap has been completely cut.