Installation Manual

FCC Regulatory notices
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Class B device notice
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
RF exposure safety
This product is a radio transmitter and receiver usable beyond a distance of 20 cm.
The antenna must be installed and operated with minimum distance of 20 cm between the radiator and
your body.
It is designed not to exceed the emission limits for exposure to radio frequency (RF) energy set by the
Federal Communications Commission.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Supplier's Declaration of Conformity 47 CFR § 2.1077 Compliance Information.
Unique Identifier: FI2-TR433UDB
Responsible Party – U.S. Contact Information
STRATTEC SECURITY CORPORATION
3333 WEST GOOD HOPE ROAD
MILWAUKEE, WI 53209 U.S.A.
Abdel Salah / Director of Engineering
414-247-3333 / [e-mail]