User's Manual

AD Plus2.0 User Manual
Page 29 of 66
99admin,120223,WIFI2,WEP,streamax,streamax,1!
99admin,120223,WIFI2,NONE,streamax,1!
Client mode:
Command parameters: Mode, Encryption Type, ESSID, Account,
Password, Static Enable, Static IP Address, Subnet Mask, and
Gateway!
0 indicates that the static IP address is enabled and 1 indicates that the
dynamic IP address is enabled.
Example:
99admin,120223,WIFI1,WEP,streamax,streamax,1!
99admin,120223,WIFI1,WPA/WPA2-PSK,streamax,streamax,1!
99admin,120223,WIFI1,WPA2.ENTERPRISE,streamax,streamax,stream
ax,1!
2) None mode:
Command parameter: Mode!
Example: 99admin, 120223, WIFI0!
10. It allows modifying server parameters by sending SMS messages. When the
server address changes or is abnormal, the device will be disconnected from
the server. All remote services of the vehicle are stopped. To avoid this
situation, you can change the IP address and port number of the device server
by sending SMS messages.
Command keyword: SMCM
Command parameters: Server Serial Number, Enable, N9M Register
Server, N9M Media Server, N9M Register
Server Port, N9M Media Server Port, Server
Serial Number, Enable, N9M Register Server,
N9M Media Server, N9M Register Server Port,
N9M Media Server Port, Server Serial Number,
Enable, N9M Register Server, N9M Media
Server, N9M Register Server Port, and N9M
Media Server Port
Remarks: 113.14.232.88 (IP address), 6605 (port number)
Enable. 0: Disable; 1: Enable
Example:
99admin,120223,SMCM1,1, 113.14.232.88, 113.14.232.88,6605,6606
(,1,1, 113.14.232.88, 113.14.232.88,6605,6606) (,1,1, 113.14.232.88,
113.14.232.88,6605,6606)
 Local
Tap Preferences > Basic Setup > Network > Local, as shown in the following
figure: