User Manual

Battery Installation/Removal
To access the battery compartment you must first remove the flashlight from the firearm. Follow the TLR Removal
Procedure instructions to remove the flashlight from the firearm.
1. Unclip the door latch.
The latch is tight. It may
help to use a coin.
2. Slide the batteries from
the flashlight.
3. Insert the new batteries
observing polarity.
Note: The flashlight is polarity
protected and will not light
if the batteries are inserted
incorrectly.
4. Hold the battery switch/door
at an angle and place
the small tab on the bottom of the
battery/door switch into the slot in
the flashlight body.
5. Firmly push and hold the door closed against the flashlight body.
6. Swing the door latch over the door and snap it into place.
Mounting/Removal Procedure
MAKE SURE THAT THE FIREARM IS UNLOADED AND THE BREECH IS OPEN. IT IS IMPERATIVE THAT SAFETY MEASURES BE
EMPLOYED AT ALL TIMES WHILE HANDLING THE FIREARM.
Fixed Portion
of Rail Clamp
Rail Clamp
Tension Bolt
Rail Key
Adjustable Portion
of Rail Clamp
Tab
Battery Door Latch
Slot
Battery Door/Switch
IMPORTANT WARNINGS
FIREARMS
MAKE SURE THAT THE FIREARM IS UNLOADED AND THE BREECH IS OPEN WHEN MOUNTING OR REMOVING THE FLASHLIGHT.
IT IS IMPERATIVE THAT SAFETY MEASURES BE EMPLOYED AT ALL TIMES WHILE HANDLING THE FIREARM.
BATTERIES
WARNING: FIRE, EXPLOSION, BURN HAZARD
USE ONLY: Streamlight, Panasonic, or Sanyo size CR123A; Duracell 123A, or Energizer 123. Use of other batteries or
mixing of used and new or different brand batteries may result in leakage, fire or explosion and serious personal injury.
DO NOT recharge, misuse, short circuit, improperly store or discard, disassemble, or heat above 212°F (100°C).
Keep away from children.
LED (TLR-1 & 2)
AVOID DIRECT EYE EXPOSURE
LED Radiation (Class 2/ Max. Output <5 mW/ Wavelength: approx. 450-550 nm)
LASER (TLR-2 only)
DANGER – LASER RADIATION IS EMITTED FROM THIS PRODUCT.
CAUTION – USE OF CONTROLS OR ADJUSTMENTS OR PERFOMANCE OR PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
AVOID DIRECT EYE EXPOSURE.
DO NOT STARE DIRECTLY INTO LASER BEAM.
DO NOT VIEW THE LASER BEAM WITH OPTICAL INSTRUMENTS
(SCOPES, SPOTTING DEVICES, BINOCULARS, ETC.).
AVOID REFLECTED LASER BEAM.
DO NOT ATTEMPT TO OPEN OR MODIFY THE LASER CARTRIDGE.
LABEL INFORMATION AND LOCATION (TLR-2 only)
This important label is affixed to the laser housing.
CAUTION - LASER RADIATION
AVOID DIRECT EYE EXPOSURE
CLASS 3R LASER PRODUCT
CLASS 2 LED
MAX OUTPUT: <5 mW
WAVELENGTH: 425 - 665 nm
AVOID EXPOSURE;
LASER RADIATION
IS EMITTED FROM
THIS APERTURE.
COMPLIES WITH 21 CFR 1040.10 AND 1040.11
AS AMENDED BY LASER NOTICE 50., 26JULY01.
LASER/LIGHT LIGHT LASER