User Manual

Maintenance
The TLR rail clamp tensioning bolt requires an application of high quality gun oil to keep it rust free. Use a soft cloth
and mild detergent to clean the glass LED lens and keep it free of dirt and grime. The laser aperture (TLR-2) can be
cleaned with a Q-tip (or similar item) and mild detergent. Note: Always avoid aggressive cleaning solutions as they
may damage the TLR.
TLR Parts
Note: The TLR rail key can be changed to accommodate several varieties of mounting rails. Remove the rail key screw
with a 7/64th hex wrench and pull the rail key from the body. Insert the new rail key and fasten it in place with the
rail key screw.
Streamlight’s “No Excuses Warranty” Streamlight warrants this product to be free of defect for a lifetime of use.
We will repair, replace or refund the purchase price, at our option, of any Streamlight product that does not work or that
you manage to break for as long as you own it. Of course, this limited lifetime warranty excludes abuse, batteries, bulbs
and chargers. Rechargeable batteries and chargers have a (1) one year warranty with proof of purchase. Please return
your Streamlight to our factory to take advantage of this guarantee. Go to www.streamlight.com for the location
of an authorized Streamlight repair center near you.
Product Registration: To register your product, go to www.streamlight.com (Online Product Registration). Retain
your receipt or any proof of purchase.
Luxeon
®
is a registerd trademark of Lumileds Lighting, Inc.
Rail Key Orientation
Lens/Bezel
Rail Key Screw
Battery Door/Switch
1. The TLR is design to be quickly attached or detached from the side of the weapon or accessory rail.
2. Loosen the rail clamp tension bolt.
3. Angle the TLR, placing the fixed portion of the rail clamp against the accessory rail and align the rail key
with the appropriate cross groove in the accessory rail.
4. Slightly depress the tension bolt to open the rail clamp, rotate the TLR into place and release the pressure
on the tension bolt to “snap” the light in place.
5. Check for fit and tighten tension bolt until the TLR is securely attached to the firearm.
Switch Operation
The TLR features a paddle switch providing momentary or constant activation.
The TLR-2 has an additional mode selection switch located on the rear of the laser housing.
TLR-2 Laser Sight Zeroing
For a laser mounted below or to the side of the bore, there is only one distance where the bullet path will coincide
with the laser sight line. This point is the “zero range.” Laser adjustment and the muzzle velocity of the bullet
determine where this point occurs. The user must decide how high above or below the sight line the bullet can be
allowed to strike and adjust the sight accordingly. At distances less than the zero range the bullet will be above the
sight line. Beyond the zero range the bullet will be below the sight line. If mounted to the side, the bullet will also
deviate to the side of the laser line, as well as up and down. In practice, a TLR-2 on a handgun can be adjusted to
keep the bullet strike within about 2” high and 2” low out to about 100 feet.
(MODE SWITCH)
Laser Laser/LEDLED
Constant
OFF (PADDLE)
Momentary
OFF (PADDLE)
Constant
Momentary
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
FAX [phone] - TestEquipmentDepot.com