Installation Guide

1
Step 2 Checking and testing
Step 1 Faucet installation
1
2
Step 3 Maintenance
B.If faucet leaks from the handle or drips from spout, please replace cartridge following the following steps:
Unscrew the cartridge locknut with
Adjustable Wrench, then take out the old
cartridge ②.
①
Place a new cartridge in the cartridge
seat, then screw the cartridge locknut
and assemble the handle by securing
the screws.
Remove the handle screw with Allen key
③, take out the handle①, then remove the
trim cap④.
②
3
4
5 6
7
8
80MM
1
Hot water
Cold water
Installation
location
Hot water
Cold water
Drill one hole of 130mmX130mm max and
drill 3 holes with 80mm diameter as shown.
Align the base① with the holes exactly as
shown.
Insert the expansion anchors① into the holes
on the base② with a hammer,tighten with
adjustable wrench.
Tighten the shower holder① into faucet
body④ with a screw② and Allen key③.
Connect flexible hose① to the connector②
correctly as shown,tighten with adjustable
wrench.
Insert 3 screws② into holes on the plate④,
tighten with Allen key③.Cover it with flange①.
1
2
1
2
3
4
1
2
4
3
2
1
1
2
3
2
Check all connections at arrows for leaks,
re-tighten it if necessary.
BUT DON'T OVERTIGHTEN
Remove the aerator ② with ,
take out the o-ring ① too.Turn the faucet
handle all the way on, turn on hot and cold
water supply and flush water lines for one
minute.Reinstall aerator with aerator wrench.
aerator wrench
1
2
1
2
3
4
1
2
1
A.If there is splash or low flow rate,please remove the aerator with the wrench and clean the debris.
1
2
3
4
5
1 2 3
Slide the flange into the welded rack
as shown, and connect the flexible hose②
to the faucet body①, then assemble the
welded rack③ to the faucet body① and fix
it with screws⑤.
④ ③
Assemble the shower hose to hand shower
and connector under the shower holder① as
shown.Then finish the installation of the faucet.
③ ②