PEDESTAL BATHTUB SERIES OWNER'S MANUAL & INSTALLATION GUIDE READ ENTIRE INSTALLATION GUIDE PRIOR TO INSTALLING THE BATHTUB THIS BATHTUB SHOULD ONLY BE INSTALLED BY A CERTIFIED PLUMBER CAUTION! TWO PEOPLE ARE REQUIRED TO LIFT THE BATHTUB QUESTIONS ON PRODUCT, INSTALLATION, RETURNS? PLEASE CONTACT streamlinebath.com support@streamlinebath.
WARRANTY RETURNS We thank you for your purchase. Here at Streamline®, our goal is to provide customers with exceptional bathroom and kitchen products. We understand that things sometimes don’t work out. If you are unsatisfied with your Streamline® product and would like to initiate a return, please reach out to support@streamlinebath.com .
PRIOR TO INSTALLING These products must be installed by a fully insured and licensed plumber only. Installation of any product by anyone other than fully insured and licensed plumber shall void limited warranty. We are not responsible for any local code compliance for this product. Building and plumbing codes may vary state-to-state. Streamline shall not be held liable for any and all incidental damages or flood caused due to use of this product.
DRAIN MODEL COMPATIBILITY FREESTANDING BATHTUB N-120-60FSWH-DM N-121-60FSWH-DM N-DWF-CH N-DWF-GLD N-180-60FSWH-DM N-960-60FSPRWH-DM N-961-68FSBL-DM N-200-60FSWH-FM N-201-68FSWH-FM N-1140-60FSWH-FM N-1141-68FSBL-FM
DRAIN DIAGRAMS No Model: N-DWF-GLD Model: N-DWF-CH ITEM Qty 1 Cover 1 2 Cover gasket 1 3 Cartridge 1 4 Strainer 1 5 Waste upper gasket 1 6 Waste lower gasket 1 7 Connector 1 8 Coupling nut 1 9 Nut 1 10 Washer 3 11 Tee 3 12 Pipe 1 13 Overflow body 1 14 Tapered rubber gasket 1 15 Overflow upper gasket 1 16 Overflow plate 1 17 Pin Bolt 1 16 Taic piece 1 17 Flange 1
BATHTUB INSTALLATION 1. Ensure that the floor at the installation site has sufficient floor support and is level. 2. Waterproofing the floor is highly recommended. 3. Determine the location of the drainpipe on the floor by taking measurements of the drain and waste location underneath the unit. Clean the drain hole area in preparation of setting the drain. The area should be dry & free from any debris. 4. Remove the bathtub from its box.
5. Gently place the bathtub in the upside-down position on a tarp or cardboard sheet in order to avoid contact with any rough surface. 6. Loosen the nuts & washers from the metal frame. Adjust the leveling feet to align with the bathtub’s bottom as well as the floor and then tighten the washer and nuts. 7. Ensure to mark all positions of leveling legs on the floor using a pencil. Move the bathtub into the desired location near the drainpipe.
. Take the strainer, place silicone sealant around it, and then place it into the drain hole ensuring a tight connection with the drain ell & gasket. Use silicone sealant. DO NOT use plumbers putty to seal. Silicone Sealant Strainer Gasket Drain Ell 9. Insert the tailpiece into the trap inlet using the O-ring, coupling nut, & flange. The tailpiece may need to be cut for proper fit. 1''-2'' of the tail piece shoudl fit inside the trap. Slip the flange over the tailpiece and slide down to the floor.
11 . Attach the tapered rubber gasket to the overflow ell. Align the overflow ell with the overflow hole & secure the drain to the tub with overflow plate and screw provided. Tapered Rubber Gasket Overflow Plate 12 . Make sure a watertight seal exists on all bath drain connections.
PEDESTAL INSTALLATION AND REPLACEMENT All parts of the pedestal have already been installed by the manufacturer prior to shipment. Below instructions are demonstrating how to replace them if repair is needed. NO. 1 2 3 4 5 ITEM Qty.
DECK MOUNT CAPABLE N-120-60FSWH-DM N-180-60FSWH-FM N-960-60FSPRWH-DM N-961-68FSBL-DM
