Operation Manual

Make sure the console and the cup holders are aligned

and then tighten the 4 screws under both sides of

console tube.(FIG-8)

1.Attach the right cup holder to the console tube and the right

handlebar. Rotate the console tube if necessary to make sure the

cup holder fits snugly on the handle bar.

2.Attach screw from the top of the cup holder onto the handlebar

and tighten.

3.Attach screw from the bottom of the cup holder to the console.

4.Repeat the above steps to fix the left cup holder on handle

bar.(FIG-7)

HANDLEBAR SUPPORT POST ASSEMBLY

1.Remove screw , and nut from both

right/left sides of base frame.

2.Stand up the support post and handle bar.

(FIG-1)

with

1.Adjust the handlebars so they are positioned

on the handlebar posts. Secure the right/left

handle bar on the support post by tightening

the screws .(FIG-4)

2.Rotate the console tube so the console

bracket is positioned as shown in Figure 4.

CONSOLE ASSEMBLY

shown in Figure 5.

wire harness

Note:lnsert excess wire harness into right side of console tube.

the

the Speed Control Harness

Incline Control Harness

Make sure all the cables/wires are not pinched

when the console screws are tightened.

CUP HOLDER ASSEMBLY

MA600/MA400

(Only for MA600)