User Manual
39
Safety During Installation
Safety While Driving
● Use this unit with a 12-volt car battery and negative ground. Failure to do so may result in re or
malfunction.
● To avoid short circuits in the electrical system, disconnect the (-) battery cable before beginning
installation.
● Before making the connections, turn o the ignition to avoid short circuits.
● Do not place wiring under screws.
● Do not run the wires where they will be exposed to high temperatures. If the insulation of the
wires becomes very hot, they can become damaged, causing a short circuit or malfunction and
possibly permanent damage to the Car Radio.
● For safety reasons, always provide insulating tape with unconnected cables.
● After installing the car radio,
● Do not use the car radio if it distracts your attention from driving your car safely. If you are
having trouble using the car radio or reading the screen, park your car in a safe place and apply
the parking brake before making any necessary adjustments.
● Do not look at the screen of the car radio and do not focus your eyes on the screen when driving
for an extended period.
● Keep the following in mind when listening to your car radio:
– Don’t turn up the volume so high that you cannot hear ambient noise, trac, and vehicles
outside.
– If the volume is too high, it may cause hearing damage or loss.
– Listen at a reasonable volume for a reasonable amount of time.
– Be careful not to continuously adjust the volume upwards as your hearing adjusts.
– Minimize the volume before turning on the car radio to avoid hearing damage from sudden
– exposure to excessive volume.
● Place the remote control where it cannot move during braking or other operations. A dangerous
situation can arise if the remote control falls and gets caught under the pedals while driving.