User Manual
PRODUCT INTRODUCTION
Some tips before you start
• If a DC power adapter is used to power the camera, please make sure there are NO batteries
in the camera in order to prevent overcharging. This will cause permanent damage to the
wildlife camera
• Do not dip or submerse the wildlife camera underwater.
• The conguration of the wildlife camera should be done when in “TEST” mode. The “ON”
mode is only used when the installation is complete and ready for real world use.
• If you observe a red ash when you take photos, please turn the switch from “TEST” to “ON”
• For best performance do not mix old batteries and new batteries.
• The camera can work in temperatures of up to 70°C but please keep the camera far enough
from re to protect the batteries.
• To change the menu language rst enter settings mode (slide mode switch to “TEST”) then
click on the menu button and go to language to select the desired language.
• After you turn the switch from “TEST” to “ON”, you will observe a countdown from
10 seconds to 0 seconds then the screen will shut down. This is completely normal. You can
walk in front of the camera to check if it takes photos and videos.
4