Installation Guide

Garage Parking Sensor
Parking just got easier!
200 Overhill Drive Suite C
Mooresville, NC 28117
www.StrikerHandTools.com
Questions? Call 704-658-9332
INTRODUCTION
Let the Parking Attendant help you consistently guide
your car to a safe stopping distance. The Parking
Attendant is low maintenance, easy to install, and
operates for about a year without having to replace
the batteries under normal use.
The Parking Attendant consists of a sensor module
and a display module. The sensor module transmits
harmless ultrasound pulses that are reflected by an
incoming object. When a vehicle is detected, more
pulses are transmitted to track the incoming vehicle
speed and distance. The display unit, mounted where
the driver can easily see it, uses a bright GREEN light to
indicate that the vehicle has been detected. A bright
YELLOW light indicates when you are close to your
stopping distance. When the vehicle reaches the
desired stopping distance, a RED light will illuminate
and stay on
INSTALLING BATTERIES
Batteries will last for approximately one year. When it
is time to replace the batteries, a flashing red LED will
appear in the display module (after the solid red LED
times out) to warn the user.
S
TOP AT 3-FEET
Detection Zone: 4-5 feet (green LED)
Slowing Zone: 3-4 feet (yellow LED)
Stop Zone: 3 feet (red LED)
Using the slide switch
located on the back of
the sensor unit, you
can set the Parking
Attendant to your
desired stopping
distance. Unit works
best when the path
between sensor unit
and car is free from
any obstructions.
Place the larger Velcro piece onto the back of the
sensor module in between the two battery
compartments.
Place the smaller Velcro piece onto the back of the
display module between the screw holes.
Clean a small area of the wall which is easily seen by
a driver of an incoming vehicle (B). Place the
corresponding Velcro piece onto this area.
Clean a small area of the wall
which is along the center line
of the parking area, at the same
height as the bumper of the
vehicle that the Parking
Attendant will be used with (A).
Make sure that all dust and
debris have been removed
from this area. The sensor
module should also be directed
towards the center of the car.
Place the corresponding Velcro
piece onto the cleaned area.
The module should hang
vertically on the wall.
MOUNTING THE PARKING ALERT
VELCRO MOUNTING:
Remove screws from the battery compartment cover
on the back of the sensor module and remove cover.
Insert 4 new AA alkaline batteries (not included)
according to polarity diagram inside battery
compartment.
Replace cover and screws.
IMPORTANT: Remove batteries before storing the
Parking Attendant for extended periods. Batteries
corrode over time and may cause permanent damage
to the unit. Different types of batteries or new and
used batteries should not be mixed. Exhausted
batteries should be removed from the unit and
disposed of properly.
SETTING THE DESIRED STOPPING DISTANCE
The Parking Attendant has 3 selectable stopping
distances.
S
TOP AT 1-FOOT
Detection Zone: 2-5 feet (green LED)
Slowing Zone: 1-2 feet (yellow LED)
Stop Zone: 1 foot (red LED)
STOP AT 2-FEET
Tracking Zone: 2-5 feet (green LED)
Slowing Zone: 2-3 feet (yellow LED)
Stop Zone: 2 feet (red LED)
1.
2.
3.
1.
2.
SCREW MOUNTING:
Four Screws required (not included). Recommend
4mm diameter pan-head screws.
Using 2 screws, mount the
sensor module along the
center line of the parking
area, at the same height as
the bumper of the vehicle
that the Parking Attendant
will be used with.
Using a screw, mount the
display module above the
sensor module where it can
be easily seen by a driver of
an incoming vehicle.
1.
2.
OPERATION
The Parking Attendant should now be properly
installed and ready to go. However, it is advised that
you test that both the modules are mounted and
functioning correctly.
TEST
Pull vehicle slowly into parking area until display unit
shows a green light (vehicle detection), then a yellow
light (vehicle tracking), and then a red light when the
stopping zone is reached.
LOW BATTERY WARNING
When the batteries in the Parking Attendant need
replacement, the display module will show a flashing
RED indicator light following all parking events.
Please replace batteries promptly following the
previous directions. The Parking Attendant was
designed to provide up to 1 year of battery life under
average use conditions.
NOTE:
Parking Attendant stop distances can vary due to
temperature, weather and vehicle type. It is important
to check your reaction time and leave sufficient
stopping distance for these variations Always test the
desired stop distance when parking a new vehicle and
adjust mounting location or stopping distance if
necessary.
The Parking Attendant was designed for slow speed
parking. For rapid entrance speeds, the display
module may not accurately reflect distance.
The Parking Attendant is not suitable for use in wet
locations.
SPECIFICATIONS
Operating
Voltage………………………………………..3.8~6.5V
Power Supply……………………...4 size AA cell (6.0V)
Low Voltage
Detection………………………………………...~4.1V
Working Mode Current………...<55m A (RED LED ON)
Standby Mode Current……………….Transmit 5.0mA
Sleep: 0.02mA
Average: 0.23mA
LED INDICATION STATE:
Detection Zone (green LED)………30-second time out
Slowing Zone (yellow LED)……….10- second time out
.top Zone (red LED)………………..15-second time out
Low Voltage Alert (red flashing LED): 60-second time out
Ultrasonic Frequency…………………………..40 KHz
Minimum Range…………………………….~6 inches
Maximum Range………………………………~6 feet
Striker products are guaranteed: Warranty against
manufacture and material defects under normal use.
INTRODUCCIÓN
Permita que el Asistente de Estacionamiento le ayude a
guiar su vehículo consistentemente hacia una distancia
segura antes de parar. El dispositivo de asistencia de
estacionamiento requiere poco mantenimiento, es fácil
de instalar y funciona casi un año sin tener que
reemplazar las baterías bajo uso normal.
El dispositivo de asistencia de estacionamiento consiste
de un módulo sensor y una pantalla. El módulo sensor
transmite impulsos inofensivos que se reflejan por
objetos entrantes. El sensor transmite más impulsos en
cuanto detecta un vehículo, siguiendo de cerca la
distancia y velocidad. La pantalla, instalada donde el
conductor puede verla fácilmente indica en VERDE que
el vehículo ha sido detectado por el sensor. Una luz
AMARILLA indica la aproximación al sitio de parada.
Una vez que el vehículo alcanza la distancia de
estacionamiento deseado, una luz ROJA se ilumina y
permanece encendida.
COMO INSTALAR LAS BATERÍAS
Las baterías duran aproximadamente un año. Cuando
es hora de reemplazar las baterías, el diodo emisor de
luz (LED) brilla intermitentemente en la pantalla
(después de que la luz fija LED se retrasa) para advertir al
usuario.
P
ARADA A 2 PIES DE DISTANCIA
Zona de detección: 4 a 5 pies (Diodo LED verde)
Velocidad lenta: 3 a 4 pies (Diodo LED amarillo)
Zona de parada: 3 pies (Diodo LED rojo)
Use el interruptor
corredizo en el dorso
del módulo sensor para
ajustar la distancia de
parada a su gusto. El
aparato funciona mejor
cuando el paso entre el
sensor y el vehículo se
encuentra libre de
obstáculos.
Coloque el pedazo de Velcro más grande en el dorso del
módulo sensor, entre el compartimiento de las dos
baterías.
Coloque el pedazo de Velcro pequeño en el dorso de la
pantalla, entre los agujeros de los tornillos.
Limpie un área pequeña en la pared que pueda ser
divisada fácilmente por el conductor del vehículo
entrante (B). Coloque el pedazo de Velcro correspon-
diente en esta área.
Limpie bien un área pequeña de
la pared a lo largo de la línea del
centro del área de parqueo, a la
misma altura del parachoques
del vehículo con el cual va a usar
el módulo (A). Asegúrese de
limpiar bien todo el polvo y
residuos de esta área. El módulo
sensor también debe
permanecer dirigido hacia el
centro del vehículo. Coloque el
pedazo de Velcro correspondi-
ente en el área limpia. El
módulo debe quedar
verticalmente en la pared.
MONTAJE DEL MÓDULO DE PARQUEO
MONTAJE CON VELCRO:
Retire los tornillos del compartimiento de las baterías
en la parte trasera del módulo sensor y retire la
cubierta.
Inserte 4 baterías alcalinas AA” (no incluidas) según el
diagrama de polaridad adentro del compartimiento.
Instale nuevamente la cubierta y los tornillos.
IMPORTANTE: Retire las baterías antes de guardar el
Asistente de Estacionamiento por largos períodos de
tiempo. Las baterías se oxidan con el tiempo y podrían
ocasionar daño permanente al aparato. No se debe
utilizar diferentes tipos de baterías ni se beben combinar
baterías nuevas con baterías usadas. Las baterías
inservibles se deben retirar y despojar debidamente.
COMO AJUSTAR LA DISTANCIA
DE ESTACIONAMIENTO DESEADA
El Asistente de Estacionamiento cuenta con 3 distancias
de parada
P
ARADA A 1 PIE DE DISTANCIA
Zona de detección: 2 a 5 pies (Diodo LED verde)
Velocidad lenta: 1 a 2 pies (Diodo LED amarillo)
Zona de parada: 1 pie (Diodo LED rojo)
PARADA A 2 PIES DE DISTANCIA
Zona de detección: 2 a 5 pies (Diodo LED verde)
Velocidad lenta: 2 a 3 pies (Diodo LED amarillo)
Zona de parada: 2 pies (Diodo LED rojo)
1.
2.
3.
1.
2.
MONTAJE CON TORNILLOS:
Se requiere cuatro tornillos (no incluidos). Se
recomienda tornillos troncocónicos de 4mm.
Monte el módulo sensor con
dos tornillos a lo largo de la
línea del centro del área de
parqueo, a la misma altura del
parachoques del vehículo con
el cual va a usar el módulo.
Use tornillo para montar la
pantalla sobre el módulo
sensor desde donde pueda
ser divisada fácilmente por el
conductor del vehículo
entrante.
FUNCIONAMIENTO
El Asistente de Estacionamiento debería estar instalado
debidamente y listo para funcionar. Sin embargo, se
recomienda verificar que ambos módulos estén bien
montados y funcionando correctamente.
PRUEBA
Tire del vehículo lentamente en aparcamiento hasta que
la unidad de exhibición demuestre una luz verde
(detección del vehículo), después una luz ámbar
(seguimiento del vehículo), y entonces una luz roja
cuando se alcanza la zona de detención.
ADVERTENCIA DE BATERÍA DESCARGADA
Cuando las baterías del Asistente de Estacionamiento
necesitan reemplazo, la pantalla del módulo exhibe una
luz ROJA después de cada intento de estacionamiento.
Por favor reemplace las baterías puntualmente según las
instrucciones citadas arriba. Las baterías de este aparato
tienen un año de duración bajo condiciones normales.
NOTA:
Las distancias de parada del Asistente de Estaciona-
miento podrían variar debido a temperatura,
condiciones ambientales o tipo de vehículo, y por eso,
es importante verificar su tiempo de reacción y permitir
suficiente distancia de parada. Siempre verifique la
distancia de parada cuando se trata de un vehículo
nuevo y ajuste el sitio de montaje y la distancia de
parada si es necesario.
El módulo sensor ha sido diseñado para estacionar
despacio. En el caso de entradas rápidas, la pantalla
podría fallar al detectar la distancia. El Asistente de
Estacionamiento no se recomienda en condiciones
húmedas.
ESPECIFICACIONES
Voltaje de
régimen………………………………………….3.8~6,5V
Fuente de alimentación……………..4 baterías AA (6,0V)
Detección de bajo
voltaje……………………..………………………..~4,1V
Modo de corriente activa………………………...<55m A
(DIODO ROJO LED ENCENDIDO)
Corriente de modo
auxiliar……………..……………….…....Transmite 5,0mA
Inactivo: 0,02mA
Promedio: 0,23mA
INDICADOR DEL DIODO LED:
Zona de detección (Diodo LED verde):
……………………………30 segundos de interrupción
Velocidad lenta (Diodo LED amarillo):
……………………………10 segundos de interrupción
Zona de parada: (LED diodo rojo):
……………………………15 segundos de interrupción
Aviso de bajo voltaje (luz roja intermitente rápida LED
……………………………..60 segundos de interrupción
Frecuencia ultrasónica………………….…………40 KHz
Alcance mínimo……………………..………….....~6 pulg
Alcance máximo…………………….…………….~6 pies
Los productos Striker están garantizados: garantía contra
defectos de material y fabricación en condiciones de uso
normal.
Garaje sensor
de aparcamiento
¡Facilidad de parqueo!
MONTAJE CON TORNILLOS
SCREW MOUNTING
VELCRO MOUNTING
MONTAJE CON VELCRO
B
A
B
A
SETTING THE DESIRED
STOPPING DISTANCE
COMO AJUSTAR LA DISTANCIA
DE ESTACIONAMIENTO DESEADA
1-FOOT
2-FOOT
3-FOOT
1-FOOT
2-FOOT
3-FOOT
200 Overhill Drive Suite C
Mooresville, NC 28117
www.StrikerHandTools.com

Summary of content (1 pages)