User's Manual
Table Of Contents
- Strix Outdoor Wireless System (OWS)
- Field Installation Guide
- OWS Field Installation
- Theory of Operation
- Important Safety Information
- Planning Your Installation
- Installing the OWS Enclosure
- Installing Antennas
- Antenna Connector Wiring Configurations
- Routing the Antenna Cables
- Grounding the OWS Enclosure
- Configuring the Power Cord
- Connecting the Ethernet Cable
- Powering Up the OWS
- OWS Product Specifications
- Appendix I: Setting the Output Power
- Appendix II: Installing the Band Pass Filter
- Index
4 OWS Field Installation
OWS Field Installation
3. For a standard 1 7/8 inch
diameter steel pole installation,
use the 2 U-bolt assemblies to
attach the enclosure to the pole
via the vertical mounting
brackets—finger tighten only.
If installing the OWS on a wider
pole (for example, a utility pole),
go directly to Step 7—skip Steps
3 through 6.
Tip: You may find it easier to
loosely attach the U-bolts to the
brackets, then slide the
completed enclosure assembly
over the pole (instead of holding
the enclosure against the pole
and attaching each U-bolt
separately).
4. Adjust the OWS enclosure to the
desired position on the pole (up
and down or rotational).
U-Bolt Assembly (x2)
Includes:
◗ U-bolt
◗ Washers (2)
◗ Nuts (2)