User's Manual
Table Of Contents
- Strix Outdoor Wireless System (OWS)
- Field Installation Guide
- OWS Field Installation
- Theory of Operation
- Important Safety Information
- Planning Your Installation
- Installing the OWS Enclosure
- Installing Antennas
- Antenna Connector Wiring Configurations
- Routing the Antenna Cables
- Grounding the OWS Enclosure
- Configuring the Power Cord
- Connecting the Ethernet Cable
- Powering Up the OWS
- OWS Product Specifications
- Appendix I: Setting the Output Power
- Appendix II: Installing the Band Pass Filter
- Index
OWS Field Installation 25
OWS Field Installation
Configuring the Power Cord
This section provides instructions for configuring the power cord (not supplied) for either AC or DC operation,
and connecting the power cord to the OWS enclosure.
Electrical Power Warning
Power Cord Assembly Caution
Parts Required
◗ AC or DC power cord (not supplied), cut to the desired length.
◗ AC/DC plug assembly.
Tools Required
This unit must be installed by a trained professional installer only. Read the installation
instructions before you connect the wireless network device to its power source.
The power cord must be assembled by a professional installer, and the final assembly
must comply with National Electrical Code (NEC) requirements, unless local codes in
your area take precedence over the NEC code.
◗ Wire stripper ◗ Flat blade screwdriver
1. Review the pin connections.
◗ Pin 1 – AC Neutral
◗ Pin 2 – DC Positive (+)
◗ Pin 3 – Ground
◗ Pin 4 – DC Negative (–)
◗ Pin 5 – AC Line
The example opposite shows an
AC plug assembly.
2. Assemble the plug and connect
the plug to the power cord of
your choice for the electrical
configuration you need, either
AC or DC.
The power cord must be
assembled by a professional
installer.
Plug Assembly
Shield
Collar
Power Cord
Locking Ring
Pin 1Pin 5
Pin 2Pin 4
Pin 3