Installation Guide
Table Of Contents
- Strix Outdoor Wireless System (OWS)
- Field Installation Guide
- OWS Field Installation
- Theory of Operation
- Important Safety Information
- Planning Your Installation
- Installing the OWS Enclosure
- Installing Antennas
- Antenna Connector Wiring Configurations
- Routing the Antenna Cables
- Grounding the OWS Enclosure
- Configuring the Power Cord
- Connecting the Ethernet Cable
- Powering Up the OWS
- OWS Product Specifications
- Appendix I: Setting the Output Power
- Appendix II: Installing the Band Pass Filter
- Index
20 OWS Field Installation
OWS Field Installation
3. Attach the omni antenna to the
pole—finger tighten only.
4. Adjust the omni antenna to the
desired position on the pole (up
and down or rotational).
5. Use a 1/2 inch nut wrench to
tighten the U-bolts (4 nuts) and
secure the omni antenna in
place.
Tighten all four nuts to 10–12
lbf.ft (1.38–1.66 kgf.m).
When tightening the U-bolts,
ensure that the bolts are not
twisted—the ends of each U-bolt
should be protruding through the
mounting bracket evenly (the
same distance).
Tighten (4 places)