Installation Guide
Table Of Contents
- Strix Outdoor Wireless System (OWS)
- Field Installation Guide
- OWS Field Installation
- Theory of Operation
- Important Safety Information
- Planning Your Installation
- Installing the OWS Enclosure
- Installing Antennas
- Antenna Connector Wiring Configurations
- Routing the Antenna Cables
- Grounding the OWS Enclosure
- Configuring the Power Cord
- Connecting the Ethernet Cable
- Powering Up the OWS
- OWS Product Specifications
- Appendix I: Setting the Output Power
- Appendix II: Installing the Band Pass Filter
- Index
OWS Field Installation 23
OWS Field Installation
Physical Layout (Wireless Modules)
The following diagram shows the physical layout of antenna connectors on the OWS wireless modules (top
view, looking down on module when the enclosure door is open).
Routing the Antenna Cables
It is important that when you install the antenna cables they are not hanging randomly and that the cables are
secured. This section provides a sample routing scenario.
1. If mounting the OWS on a pole,
route the antenna cables through
the OWS enclosure mounting
bracket and secure with cable
ties.
Ensure that the cables are not
twisted.
2. If mounting the OWS on a wall,
the cables should be fixed to the
wall with a suitable cable clamp.
G ANT1 G ANT2 A ANT2 A ANT1