Installation Guide
Table Of Contents
- Strix Outdoor Wireless System (OWS)
- Field Installation Guide
- OWS Field Installation
- Theory of Operation
- Important Safety Information
- Planning Your Installation
- Installing the OWS Enclosure
- Installing Antennas
- Antenna Connector Wiring Configurations
- Routing the Antenna Cables
- Grounding the OWS Enclosure
- Configuring the Power Cord
- Connecting the Ethernet Cable
- Powering Up the OWS
- OWS Product Specifications
- Appendix I: Setting the Output Power
- Appendix II: Installing the Band Pass Filter
- Index
26 OWS Field Installation
OWS Field Installation
The AC
1
connector you use at the
other end of the power cord
depends on the AC power source
you are connecting to. Refer to
AC Wiring Configurations on
page 27.
3. Attach the plug to the enclosure’s
power receptacle.
4. Turn the locking ring of the plug
and hand tighten to make the
connection.
5. Install an appropriate AC or DC
connector at the other end of the
power cord.
1. If using an AC power source, to comply with FCC standards for
radiated spurious EMF emissions a 30 MHz to 1 GHz ferrite core must
be attached to the AC power cord in a double-turn configuration (as
close to the OWS enclosure as possible. A suitable ferrite core for this
purpose can be obtained from Fair-Rite Products Corporation, part
number 0444164181 (round cable snap-it model).
Power Receptacle Plug
Locking Ring