Installation Guide
Table Of Contents
- Strix Outdoor Wireless System (OWS)
- Field Installation Guide
- OWS Field Installation
- Theory of Operation
- Important Safety Information
- Planning Your Installation
- Installing the OWS Enclosure
- Installing Antennas
- Antenna Connector Wiring Configurations
- Routing the Antenna Cables
- Grounding the OWS Enclosure
- Configuring the Power Cord
- Connecting the Ethernet Cable
- Powering Up the OWS
- OWS Product Specifications
- Appendix I: Setting the Output Power
- Appendix II: Installing the Band Pass Filter
- Index
28 OWS Field Installation
OWS Field Installation
Connecting the Ethernet Cable
This section provides instructions for configuring the CAT5 Ethernet cable.
Parts Required
◗ Plenum-rated CAT5 Ethernet cable, cut to the desired length (not supplied).
◗ RJ45 plug assembly.
Tools Required
◗ Wire stripper ◗ Continuity checker
1. Review the pin connections.
◗ Pin 1 – TXD+ (TX Data)
◗ Pin 2 – TXD- (TX Data)
◗ Pin 3 – RXD+ (RX Data)
◗ Pin 4 – Not used
◗ Pin 5 – Not used
◗ Pin 6 – RXD- (RX Data)
◗ Pin 7 – Not used
◗ Pin 8 – Not used
Pin 1
Pin 8
Pin 2
Pin 3
Pin 4
Pin 7
Pin 6
Pin 5