User's Guide Part 3

Access / One
®
Network
68 Managing the Network
5
Commands
Clicking on Commands in Manager/One’s toolbar generates a pull-down menu
containing all the commands that are available within the Manage function.
Load Firmware on Network
This command allows you to load a new firmware image to each of the modules
contained in all network nodes within your Access/One Network. However, before
you can load a new image, your FTP server parameters must be established correctly
to let Manager/One know where to locate the new image (BIN) file.
To establish the correct FTP parameters and load new firmware at the network level,
go to “Updating the Firmware” on page 35.
Reboot Network
This command reboots each module in all of the nodes within your Access/One
Network. Rebooting is required when network-level configuration changes are
made or a new firmware image is loaded.
To monitor the progress of the reboot operation, the network server generates the
request in stages. When each module reports receiving the reboot command and
successfully reboots, the network server performs a final self-reboot. You can
monitor reboot progress reports with the View Action Status command.
Whenever you initiate the Reboot Network command, the system warns you that
this action will affect multiple devices on the network and asks you to confirm the
request. If you want to proceed, click on the OK button to initiate the reboot
process, otherwise click on the Cancel button to abort the command.
See also, “Important Note About Rebooting” on page 4.
Update Node Names
This command must be executed at the node level. Go to “Update Node Names” on
page 128.