User's Manual

USER GUIDE
DHCP: dynamic host configuration protocol. A method for dynamically assigning IP addresses
to devices on a network. Issues IP addresses automatically within a specified range to devices
such as PCs when they are first powered up. The device retains the use of the IP address for a
specific license period defined by the system administrator.
DSSS: direct sequence spread spectrum. Combines a data signal at the sending station with a
higher data rate bit sequence, which many refer to as a chip sequence (also known as processing
gain). A high processing gain increases the signal’s resistance to interference. The minimum
processing gain that the FCC allows is 10, and most products operate under 20.
EAP: extensible authentication protocol. A general point-to-point protocol that supports
multiple authentication mechanisms. Defined in RFC 2284, EAP has been adopted by IEEE
802.1X as an encapsulation protocol for carrying authentication messages in a standard message
exchange between a user (client or supplicant) and an authenticator.
EAPoL: EAP over LAN. An encapsulated form of the Extensible Authentication Protocol
(EAP), defined in the IEEE 802.1X standard, that allows EAP messages to be carried directly
by a LAN media access control (MAC) service between a user (client or supplicant) and an
authenticator.
EAP-TLS: extensible authentication protocol with transport layer security. Used for 802.1X
authentication. EAP-TLS supports mutual authentication and uses digital certificates to address
the mutual challenge. The authentication server responds to a user authentication request with a
server certificate. The user then replies with its own certificate and validates the server certificate.
EAP-TLS algorithm derives session encryption keys from the certificate values. The
authentication server in turn sends the session encryption keys for a particular session to the
user after validating the user certificate.
encryption: Any procedure used in cryptography to translate data into a form that can be
decrypted and read only by its intended receiver.
Ethernet: A LAN architecture that uses CSMA to allow the sharing of a bus-type network.
IEEE 802.3 is a standard that defines Ethernet.
Ethernet repeater: Refers to a network element that provides Ethernet connections among
multiple other elements sharing a common collision domain. Also referred to as a shared
Ethernet hub.
FHSS: frequency-hopping spread-spectrum. One of two types of spread-spectrum radio
technology used in wireless LAN (WLAN) transmissions. The FHSS technique modulates the
data signal with a narrowband carrier signal that “hops” in a predictable sequence from
frequency to frequency as a function of time over a wide band of frequencies. Interference is
reduced, because a narrowband interferer affects the spread-spectrum signal only if both are
transmitting at the same frequency at the same time. The transmission frequencies are
determined by a spreading (hopping) code. The receiver must be set to the same hopping code
and must listen to the incoming signal at the proper time and frequency to receive the signal.
66