User's Manual

6 EWS-150g Configuration Guide
EWS-150g Configuration Guide
About the Country Code
The EWS-150g uses the US (United States) as the default country code. You are solely responsible for setting
the correct country code to ensure full compliance with your local regulatory laws for wireless
communications. Only the US and Canada are presented in the list of available country codes.
To set the country code, click on the Configure tab then click on General to display the General Settings
window.
Figure 5. General Settings Window
In the Country Code field, select the country code from the pull down list that applies to your geographic
location (either the United States or Canada). All examples from this point forward assume that the US is your
country of choice. If you change the country code to Canada you are presented with a warning to remind you
that it is your responsibility to comply with your local regulatory laws for wireless communications. You must
click on the OK button to acknowledge that you understand your responsibility.
Figure 6. Warning
If you change the country code, click on Update to apply your change then click on Reboot to reboot the
EWS-150g. Only after the unit reboots will your selected country code become active.