User's Guide

MWS100 Configuration Guide
FCC Notice
This wireless network device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: 1. This device may not cause harmful
interference. 2. This device must accept any interference received, including interference
that may cause undesired operation. This wireless network device has been tested and
found to comply with the limits for a Class B digital device pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This wireless network device generates, uses,
and radiates radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this wireless
network device does cause harmful interference to radio or television reception, which
can be determined by turning the wireless network device off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna; Increase the separation between the wireless
network device and the affected receive; Connect the wireless network device into an
outlet on a circuit different from that to which the receiver is connected; Consult the
dealer or an experienced radio/TV technician for help.
European Community (EC) Directives and Conformity
This wireless network device is in conformity with the Essential Requirements of R&TTE
Directive 1999/5/EC of the European Union.
Non-Modification Statement
Unauthorized changes or modifications to Strix devices are not permitted. Modifications
to Strix devices will void the warranty and may violate FCC or other regulations.
RF Exposure Requirements
To ensure compliance with FCC RF exposure requirements, the antenna used for this
wireless network device must be installed to provide a separation distance of a minimum
of 40cm or more from all persons, and must not be co-located or operated in conjunction
with any other antenna or radio transmitter. Installers and end-users must follow these
installation instructions.
Professional Installation Only
This unit must be installed by a trained professional installer only.