Installation Manual

OWS Field Installation 31

OWS Field Installation

4. Perform a continuity check on

each pin to verify that the

Ethernet cable

has been

assembled correctly.

2. Assemble the RJ45 plug/cable.

◗ Item 1 – Shielded RJ45 plug

◗ Item 2 – Gasket seal

◗ Item 3 – Plug holder

◗ Item 4 – Coupling ring

◗ Item 5 – Seal assembly

When assembling the plug, take

care not to lose the gasket seal

(item 2)—it must be in place

when the assembly is complete.

3. Install an RJ45 plug at the other

end of the cable.

1. To comply with FCC standards for radiated spurious EMF emissions a

30 MHz to 1 GHz ferrite core must be attached to the Ethernet cable in

a double-turn configuration. A suitable ferrite core for this purpose can

be obtained from Fair-Rite Products Corporation, part number

0444167281 (round cable snap-it model).

5. Unscrew the protective cap, then

connect the Ethernet cable to the

OWS enclosure.

Turn the coupling ring clockwise

(1/4 turn) to make the

connection.

The connection is locked when

you feel and hear a click.

Cap