User's Manual Part 2

Access / One

Network

The Manager/One Interface 59

You will always know which tabbed page you have selected because the active tab

is displayed as BLUE/GRAY (see Figure 43). Manager/One’s tabbed pages have the

following functions:

◗ Manage

At the network level, this page provides a set of commands that allow you to

manage your Access/One Network at either the network or subnet levels. At

the module level, the available command set from this page is different and

any management commands you initiate are applied only to the module you

are logged into.

◗ Configure

This page provides a set of commands that allow you to configure your

Access/One Network at the network level only (not subnets). If you are

currently looking at a subnet, clicking on this tab will default you to the

network level. At the module level, the available command set from this page

is different and any configuration commands you initiate are applied only to

the module you are logged into.

◗ Inventory

Clicking on this tab generates an inventory list in the main window, showing

the current inventory status of your Access/One Network (not available at the

module level).

◗ Monitor

Provides a set of monitors that allow you to view the active state of your

network and its components (the available monitors are different depending

on which level of the network you are logged into).

◗ Apply Configuration

If there are any configuration changes that need to be applied across the

network the color of this tab changes to BLUE. When blue, click on this tab to

apply your changes (not available at the module level).

◗ Rogue Devices

Shows a list of any rogue AP devices that are detected by your Access/One

Network modules (not available at the network level).