User's Manual Part 3

Access / One
®
Network
Managing the Network 91
5
Operating Environment
This command is applicable to the IWS only. It displays the Fan Setting window and
allows you to choose between a Low, Normal (Indoor) and Outdoor speed setting
for the node’s cooling fan. Choose Normal if the affected node is to be installed in
an environment with a regulated temperature, otherwise choose High if the
operating environment is uncontrolled and prone to fluctuating temperatures and/or
humidity. Generally, the Normal setting is used for indoor applications while the
High setting is used for outdoor applications. Only use the Low setting for nodes
with single radio configurations.
Figure 71. Setting the Cooling Fan Speed
After inputting data (or making selections), click on the Update button to update this
page, then click on the Apply Configuration tab to propagate your changes across
the network. If necessary, you can click on the factory default (FD) button in the
toolbar to reset all data on this page to its factory default state.
Firmware Updates
This command allows you to set FTP parameters at the network level so that your
Access/One Network knows where to find the new firmware (BIN) files. Procedural
information for updating your Access/One Network’s firmware has already been
covered in “Updating Firmware Across the Network” on page 37.
If you are uncertain about your FTP server’s configuration parameters, consult with
your network administrator.