User's Manual Part 3

Access / One

Network

Managing the Network 77

Trusted IP Addresses

This command allows you to enable or disable the Trusted Mode and assign specific

trusted IP addresses. When this mode is enabled, only addresses assigned here will

be trusted by the network for management at any network module.

Figure 59. Assigning Trusted IP Addresses

The following options are available with this command:

◗ Trusted Mode

You can only enable this option if you have added at least one trusted IP

address. Once a trusted IP has been added, check this box to enable the

trusted mode (or uncheck the box if you want to disable this feature).

◗ IP Address

You must add at least one IP address if you want to enable the trusted mode

feature. To add an address, simply enter a valid IP address in this field then

click on the Add button (the new address is listed below this field). You can

add as many trusted IP addresses as you want. To delete an address, click on

the X icon alongside the address, then confirm your request at the pop-up

dialog. However, if you have only one trusted IP address listed, you cannot

delete the address if the trusted mode is enabled—you must disable the

trusted mode before attempting to delete a sole trusted IP address.

After inputting data (or making selections), click on the Update button to update this

page, then click on the Apply Configuration tab to propagate your changes across

the network. If necessary, you can click on the factory default (FD) button in the

toolbar to reset all data on this page to its factory default state.