User's Manual Part 4

Access / One
®
Network
146 Managing Modules
7
◗ File Name
If you are calling a file other than accessone.bin or accessone_m.bin for this
module, enter the name of the file in this field.
When finished, click on the Update button to update this page and apply your
changes, then click on the Reboot button to reboot the module. If necessary, you
can click on the Refresh button in the toolbar to reset all parameters on this page to
their original values.
Wi-Fi
This area of Manger/One applies only to wireless modules (not network servers) and
contains commands that allow you to configure the module’s Wi-Fi parameters. Any
configuration parameters that you apply to the module will supersede the equivalent
system-level parameters that were applied at the network level and propagated to
the module from the Apply Configuration tab.
The menu structure under the Wi-Fi option is slightly different, depending on
whether you are logged in to a single band wireless module or a dual band wireless
module. The differences between the menus are as follows:
Figure 114. Single and Dual Band Wi-Fi Menu Structure
◗ Wi-Fi (single band radio)
• Radio Parameters
• Client Connect
• Network Connect
• Rogue Scan
◗ Wi-Fi (dual band radio)
• 802.11a Radio
– Parameters
– Client Connect
– Network Connect
– Rogue Scan
• 802.11g Radio
– Parameters
– Client Connect
– Network Connect
– Rogue Scan