User's Manual

Access / One
®
Network
Managing Modules 135
7
Actions
This area of Manger/One applies to all modules (wireless modules and network
servers) and contains commands that allow you to establish factory default settings,
load firmware and/or configuration files, and page or reboot the module.
Factory Defaults
This command allows you to set the module’s configuration settings to their factory
default state or remove the subnet and/or network configuration parameters from the
module.
Figure 105. Device Configuration Window
Make your selection(s) from the available options:
◗ Set Device Configuration To Factory Defaults
Enable this option to reset the module to its factory default state.
◗ Remove Sub-cloud Configuration From Device
Enable this option to remove any configuration settings that were applied to
the module at the subnet level.
◗ Remove Cloud Configuration From Device
Enable this option to remove any configuration settings that were applied to
the module at the network level.
After making your selections, click on the Factory Default button to apply your
changes, then click on the Reboot button to reboot the module.