User's Manual

Access / One
®
Network
Managing Modules 143
7
Trusted IP Addresses
This command is the same as its corresponding command at the network level. To
configure these options for the module, go to “Trusted IP Addresses” on page 143.
When finished, click on the Update button to update this page and apply your
changes, then click on the Reboot button to reboot the module. If necessary, you
can click on the Refresh button in the toolbar to reset all parameters on this page to
their original values.
TCP/IP Settings
This command is similar to the TCP/IP Settings command used at the network level,
with the addition of the IP Settings option. For all other TCP/IP configuration
options, go to “TCP/IP Settings” on page 78.
Figure 112. TCP/IP Settings (Module Level)
◗ IP Settings
Choose whether you want the system to use DHCP to obtain the module’s IP
address automatically (default), or use a pre-configured static IP address. If
you choose the latter option, you must enter a valid IP address and Subnet
Mask in the appropriate fields.