User's Manual

Access / One
®
Network
Managing Subnets and Nodes 129
6
Commands (at the Subnet Level)
Load Firmware...
This command allows you to load a new firmware image to each of the modules
contained in all network nodes within your Access/One Network or to a specific
subnet. However, before you can load a new image, your FTP server parameters
must be established correctly to let Manager/One know where to locate the new
image (BIN) file.
To establish the correct FTP parameters and load new firmware at the network or
subnet levels, go to “Updating the Firmware” on page 35.
Subnet
Choose this option to load new firmware to all devices within the selected subnet.
Network
Choose this option to load new firmware to all subnets and devices within your
entire Access/One Network.
Reboot...
This command reboots each module in all nodes within your Access/One Network
or a selected subnet. Rebooting is required when configuration changes are made or
a new firmware image is loaded. To monitor the progress of the reboot operation,
the network server generates the request in stages. When each module reports
receiving the reboot command and successfully reboots, the network server
performs a final self-reboot. You can monitor reboot progress reports with the View
Action Status command or from the Command Progress pane.
Figure 102. Command Progress Pane
Success