User's Manual Part 4

Access / One
®
Network
144 Managing Modules
7
When finished, click on the Update button to update this page and apply your
changes, then click on the Reboot button to reboot the module. If necessary, you
can click on the Refresh button in the toolbar to reset all parameters on this page to
their original values.
Priority/One - Class of Service
This command is the same as its corresponding command at the network level. To
configure these options for the module, go to “Priority/One - Class of Service” on
page 81.
When finished, click on the Update button to update this page and apply your
changes, then click on the Reboot button to reboot the module. If necessary, you
can click on the Refresh button in the toolbar to reset all parameters on this page to
their original values.
Radius Accounting
This command is the same as its corresponding command at the network level. To
configure these options for the module, go to “Radius Accounting” on page 84.
When finished, click on the Update button to update this page and apply your
changes, then click on the Reboot button to reboot the module. If necessary, you
can click on the Refresh button in the toolbar to reset all parameters on this page to
their original values.
Syslog
This command is the same as its corresponding command at the network level. To
configure these options for the module, go to “Syslog” on page 85.
When finished, click on the Update button to update this page and apply your
changes, then click on the Reboot button to reboot the module. If necessary, you
can click on the Refresh button in the toolbar to reset all parameters on this page to
their original values.