User's Manual

Sensor ID Exchange Mode (S- 3)
After rotation of tires, the Sensor ID data in the receiver must be changed accordingly to ensure that it indicates
the correct tire when there are any irregularities.
Step 1
Press [OK] button to enter ID Exchange mode.
Figure 31
Step 2
The Front left tire icon and its corresponding ID digit will blink.
1. Use [+] and [-] button to change the selected Sensor ID digit.
2. Press [OK] to confirm the changes and the next ID digit will blink
accordingly.
3. Repeat step 1 and 2 for all other ID digits.
4. The ID number ‘5’ will only be available if the spare tire setting is
‘ON’
Figure 32
Step 3
Press [T] button to quit the ID Exchange mode without saving and
return back to Programming Main menu display.
Figure 33
Step 4
The receiver will return back to Programming Main menu display and
that complete the process of exchanging Sensor ID data in the
receiver.
Note
The receiver will not save the information if any of the tires are found
to have identical Sensor ID.
Figure 34
Note
1. Value shown is for reference only.
Page 12