User's Manual

Sensor ID Learning Mode (S- 4)
For programming of a new receiver unit with ID Learning Mode, refer to the following steps.
Step 1
Press [OK] button to enter the ID learning Mode.
Figure 35
Step 2
1. The front left tire icon will blink. Toggle [+] or [-] button to
select the desired tire and press [OK] to accept the desired
location. The corresponding tire ID number blinks (once per
second) to indicate that it is ready to accept new Sensor ID
input.
2. Inflate or deflate the corresponding tire by at least 28Kpa
(4Psi).
3. When the new ID code is received, the tire icon will blink at a
faster rate (twice per second); the ID number stops blinking
and the module will beep for 5 second.
4. Press [OK] button to save the sensor ID.
5. Repeat Step 1 to 3 for other tire sensor(s) that needs to be
replaced.
Note
ID ‘5’ will only be able to receive sensor signal if the Spare Tire
setting is ON. (Refer to Spare Tire On/Off Mode (S- 6))
Figure 36
Step 3
Press [T] button to return to Programming Main menu display.
Figure 37
Note
1. The receiver will not save any identical Sensor ID.
2. Value shown is for reference only.
Page 13