Product Manual

FixturePoint Welding Table - Part No. TBH90604
Assembly Instructions
1
2
Tabletop-only configuration - 1
To use in the tabletop-only configuration, place the
FixturePoint Tabletop (A) upside down on a sturdy
surface.
Screw the four Leveling Feet (D) into the bottom hole on
each short leg of the Tabletop Frame. Place tabletop
assembly in the upright position, and adjust Leveling
Feet as needed to level the tabletop.
When the tabletop is level, turn upside down again, and
tighten all four Jam Nuts to lock the Leveling Feet into
position.
Stand-alone configuration - 2
If Leveling Feet are attached to the welded Tabletop
Frame (short legs), remove the fourfeet and set aside.
Assemble Table Leg and Leg Brace (B & C). Place the Leg
Brace in the upright position. Mount all four Table Legs
to the frame using 8 pcs. of Hex Socket Screws, M6 x
15 with Washers and Hex Nuts (F).
Place the FixturePoint Tabletop (A) upside down on a
sturdy surface. Set the leg assembly over the tabletop,
making sure mounting holes on the leg assembly align
with mounting holes on the welded Tabletop Frame.
Attach leg assembly to the tabletop using 16 pcs. of
Hex Socket Screws, M6 x 15 with Washers (E).
Tighten all screws. Screw Leveling Feet (D) into the
bottom hole on each Table Leg.
Place the assembled table in the upright position. Adjust
the Leveling Feet as needed to level the table. When the
tabletop is level, turn upside down again, and tighten
Jam Nuts to lock the Leveling Feet into position.
NOTE: The FixturePoint Table may be used in two configurations:
1. Tabletop only (set on top of level, sturdy surface), such as a workbench.
2. Full assembly, with four table legs (included) attached for stand-alone use.
The Four leveling feet (included) can be used with either configuration for proper leveling of the table.