User manual

PART 1 • English

1.4 Accessories:

1. 1 User Manual

2. 1 Remote control unit

3. 2x Batteries (AAA type)

NOTE: The batteries should not be recharged, disassembled, electrically short-

circuited or be mixed or used with other types of batteries.

If rechargeable accumulators instead of batteries are going to be used, we

recommend using (e.g. NiMH) types with low self-discharge to ensure long

time operation of remote control.

2.0 CONNECTION

2.1 Connecting to TV and Terrestrial Antenna

To receive the broadcast signal, the terrestrial antenna cable should be connected to the ANT IN

connector at the back of the receiver. (Fig. 1)

2.2 Connecting to a Digital Audio Ampliﬁer

Connect your Digital Audio Ampliﬁer with the S/PDIF connector on the back of the receiver (Fig. 1).

3.0 YOUR RECEIVER

3.1 Front Panel

Fig. 2

1. USB Connects to USB device

3.2 Rear Panel

Fig. 3

1. ANT IN To connect an antenna for reception of broadcasting signal.

2. TO TV To connect a TV set or to connect an extra receiver.

3. S/PDIF Coaxial To connect your receiver to digital audio ampliﬁer.

4. TV SCART Connector

To connect your receiver with your TV set using a SCART cable.

5. Power Cord

Your receiver requires a voltage of 220-240V AC (Auto-selectable), 50/60Hz +/-5%. Make sure to

check the power speciﬁcation before connecting your receiver to the wall outlet.

3.3 Remote Control

Fig. 4

1. q Turns the receiver On/Standby

2. ! Mutes audio output of the receiver

3. PG+/PG- Page up/down

4. DTV/VCR No function