User manual

PART 1 • English
7
English
highlight Search and press OK to start scan. After Channels are found, they will be stored and receiver switches
to the first one saved in the list.
5.2.3 Antenna Setting
1. Press MENU to enter main menu.
2. Use the pq buttons to select Installation, press OK to enter the menu.
3. With the pq buttons select Antenna setting and press OK to enter.
4. Press the tu buttons to change setting. If On is selected, the receiver will provide 5 V antenna power (for
active antennas).
5. Press EXIT button to exit.
5.2.4 Logical channel numbering
If LCN (Logical Channel Number) is activated and LCN signal is provided by operator, then channels will be stored at operator
defined order. You can activate/deactivate the LCN function by setting the "LCN Mode" to ON/OFF.
5.3 Setup
This menu allows you to set OSD Language, TV System, Region and Time, Timer Setting, OSD Setting and Parental Lock.
1. Press pq buttons to highlight desired menu and press OK button to enter the setting menus. Then press
pq buttons to select desired item. Settings can be changed by pressing tu buttons. You can get better
overview if press OK first. Now you can select desired setting by pq buttons and confirm it with OK.
2. Press EXIT button to exit.
5.3.1 OSD Language
This menu allows you to set OSD Language.
5.3.2 TV System
This menu allows to setup different settings concerning your TV set.
Display Mode: PAL/NTSC/AUTO
Aspect Ratio: Use this menu to configure the screen aspect between: 4:3 PS (Pan&Scan), 4:3 LB (Letter Box) and 16:9 (Wide
Screen)and AUTO.
Video Output: Switch the video output mode either to RGB or to CVBS
RF System: Use this option to set the mode for the modulator output to PAL-BG, PAL-I, PAL-DK, or NTSC.
RF Channel: Use this option to select the RF channel for the modulator. Please choose a channel which is not already
being used by a local broadcaster or by other equipment in your home to prevent interference.
Loop through: Use this option to set the preferred loop-through mode:
Running mode: The loop-through will be switched off when the receiver is in standby mode.
Always: The loop-through is always ON.
Note: Above setting "Always" increases the power consumption in standby mode.
5.3.3 Region and Time
Here you can set your region and time zone.
Region: This menu is used for changing the region setting.
GMT Usage: This menu is used for usage of GMT.
The options are: Off / User Define / By Region
GMT Offset: This menu is valid only when selected “User Define” in GMT Usage menu. The GMT offset range is
“-11:30 ~ +12:00”, increasing by half hours progressively.
Date/Time: “Date” and “Time” menus are valid only when selected “Off” in GMT Usage menu. Press OK then
numeric button to change the date and time.
Time Display: This menu allow to control whether the time is displayed on screen or not. The options are: Off/On.
5.3.4 Timer Setting
In this menu you can set a programme timer, sleep timer and automatic standby.
Programme timer
Timer Number: You can set 8 timers
Timer Mode: Off/Once/Daily/Weekly/Monthly
Timer Service: TV Service/Radio Service
Wake-up Channel: You can select a desired channel as wake-up channel.
Month/Date/Day: Press pq buttons to select your desired month, date and day.Time: Press OK to input the time with
the numeric buttons.
Auto Record: Use tu to adjust ON or OFF, depending if you want the timer to activate recording via USB device.
Duration: Press OK to input desired duration with the numeric buttons.
Quitting the programme timer, a saving window appears, select Yes in the confirmation window with tu and press OK
to save or select No to cancel.